Hi all,
My X-Sabre 3 requires turning the power off at the power point in order to locate the LAN signal again.
The LAN dropouts occur when going into standby, only recoverable by powering off and on at the power point.
I do also turn the WiFi extender (which is the LAN source) off after going into standby mode.
When I turn the LAN source back on again, the X-SABRE 3 will not locate the LAN input unless I do a full reboot.
Firmware version is 1.1.1 Build007 - Latest as at time of posting 8th June 2024.
Thanks in advance for your advice.
Fabulous product by the way :-)
Rob
NSW Australia
My X-Sabre 3 requires turning the power off at the power point in order to locate the LAN signal again.
The LAN dropouts occur when going into standby, only recoverable by powering off and on at the power point.
I do also turn the WiFi extender (which is the LAN source) off after going into standby mode.
When I turn the LAN source back on again, the X-SABRE 3 will not locate the LAN input unless I do a full reboot.
Firmware version is 1.1.1 Build007 - Latest as at time of posting 8th June 2024.
Thanks in advance for your advice.
Fabulous product by the way :-)
Rob
NSW Australia
