07-02-2024, 04:58 PM
(这个帖子最后修改于: 07-02-2024, 05:02 PM by Dmitry_3834.
编辑原因: add firmware info
)
(06-18-2024, 07:12 AM)LI HUI 提到:The error occurred again twice. In the same sequence as before:(06-18-2024, 06:39 AM)Dmitry_3834 提到: For my audio system I use a power distributor with EMI filters. Matrix mini-i 4 is connected to a separate power filter output.Hi Dmitry，
Can you connect your mini-i 4 to the power mains directly, and then take a note will the issue happen again.
1. Pressed the Standby button on the remote control;
2. The text "Standby..." was displayed and the display turned off;
3. The relay clicked;
4. The display turned on again with the text "SETTINGS SAVED";
5. Then after a second the error codes were displayed.
I rebooted the device by long pressing the power button. The device turned on... I pressed the standby button on the remote control again... And again the error codes appeared as in the first example, but this time without step 4. After the second reboot, the device turned off normally. It is not yet possible to understand after what actions this happens.
Firmware version：V1.0.9 Build005
